inferno tankomizer

[Tee]

I used the tankomizer for 2 days and now nothing happens. It's not working now. How do Iget this to work again??

[Samurai Vaper]

Do you feel the tankomizer getting warm or hot when you activate the battery? Or maybe the connector plate under the tankomizer went in a little too far causing it not to touch the plate on the battery. Try this and see if it works: non-poorly-firing-atty-try-this-before-tossing-t1662.html

[Tee]

No, it's not firing at all. The batteries are fine with all my other tanks. I tried the plate trick and the plate won't budge.

[Artist Boy]

did you try the plate on the batteries? that move as well......

the coil might have just popped. it happens sometimes. I hope that is not the case, but t can happen.


Did it die in mid vape, between vapes, or after a battery change? Or over night?

Does it feel warm at all when you try to use it?

does it make any noise at all? maybe a gurgle or anything?

[Tee]

No AB, I tried all of that and it is absolutely dead- no noise=nothing! I cannot get the plate on the atty to budge, although the batteries are just fine. It just happened last night. One minute It was working and then it just quit. Thanks for all of your help, everyone!

[YogiBeerBear]

Sounds like it popped to me.

[Tee]

Yes, I think it did. So, I got a replacement today and was wondering if there is suppose to be a tight draw on this. The one that popped didn't seem to have that tight of a draw. Just wondering if this is normal and if that was part of the cause of the old one to 'pop'??

[rawrrrdino]

did you remove the o-ring from the inferno battery?

[Tee]

Yes. Everything is all good now. I just received a bad one, I guess. I have 3 new, that work just fine. Thanks for your concern, raw!